Zinc-phosphate containing anticorrosive shop primer which provides high adhesion and good corrosion-resistance for metal sheet surfaces.

Surface Preparation&Application
Surfaces should be cleaned of old paint film, oil, dust, dirt, moist, chloride, sulphate salts, rust, rolled mud, tempering, casting - welding burrs etc. which will reduce adhesion on the application surface . Metal surfaces must be sanded at minimum Sa2 ½ (ISO 8501-1, SSPC-SP10) (sand blasting), prime the sanded surface with Unipox Shop Primer in 6 hours. After the primer has fully dried (in 4 to 6 hours), Epoxy Anticorrosive Primer and top coat paint can be applied. Mix the primer and the hardener in the given ratio until a homogeneous mixture is obtained. Rest the mixture for 2 to 3 minutes for preliminary reaction and apply with the recommended tools. The Surface temperature must be minimum 3 degrees Celsius higher than the dew point. Application at temperatures near the dew point is not recommended. For the topcoat application wait for 24 hours between coats. Application Temperature: Min. +10°C / Max. + 30°C

Thinning / Blending Ratio
7 A / 1 B - Epoxy thinner 5- 10% by weight

Coverage Area
6-17 m²/L or 11-12 m²/kg (15 - 20µ DFT)

Drying Time
Touch dry in 4-5 minutes and hard dry in 24 hours.

Recommended Application Tools
Air - airless spray

Package
20 kg Set (17.5 kg A + 2.5 kg B)

Sitemizin işlemesini sağlamak için çerezler kullanılmaktadır. Detaylı bilgi almak için Polisan Kansai Çerez Aydınlatma Metni'ni incelemenizi rica ederiz.