Marine&Marine Anti Aging PU Seam Filler Putty

The application surface should be cleaned from any kind of stain, rust, grease and loose paint and coating layer, sanded or roughened. The dew point should be monitored during application and treating moist or wet surfaces should be avoided. Moist and/or water may cause abnormal bubbling of the product. Based on the given blending ratio, the product should be mixed homogenously with the hardener. Should be rested for 3-4 minutes. It should be applied in thin layers to fill deep cracks and indents. And 4 – 6 hours should be waited between each coat. If waited for longer than 24 hours, then the surface should be sanded slightly.

4 units of PU Seam Putty + 1 unit of PU Seam Putty Hardener by weight. Used without thinning.

For seam applications, approximately 150 g putty is required for 1 m² cross section. For coating applications, approximately 450 – 500 g putty is required for 1 m² when applied for creating a dry film of 250 microns. Coverage area varies in practice according to surface roughness and spillage.

At 20°C, the putty is touch-dry in 6 hours, antidust-dry in 12 hours and hard-dry in 24 hours. For mechanical process, fully dry in 4 to 6 days.

Spatula, putty knife, floating rule.

1 kg - 4 kg - 20 kg