Zinc-phosphate containing anticorrosive shop primer which provides high adhesion and good corrosion-resistance for metal sheet surfaces.

Surface Preparation&Application
Surfaces should be cleaned of old paint film, oil, dust, dirt, moist, chloride, sulphate salts, rust, rolled mud, tempering, casting - welding burrs etc. which will reduce adhesion on the application surface . Metal surfaces must be sanded at minimum Sa2 ½ (ISO 8501-1, SSPC-SP10) (sand blasting), prime the sanded surface with Unipox Shop Primer in 6 hours. After the primer has fully dried (in 4 to 6 hours), Epoxy Anticorrosive Primer and top coat paint can be applied. Mix the primer and the hardener in the given ratio until a homogeneous mixture is obtained. Rest the mixture for 2 to 3 minutes for preliminary reaction and apply with the recommended tools. The Surface temperature must be minimum 3 degrees Celsius higher than the dew point. Application at temperatures near the dew point is not recommended. For the topcoat application wait for 24 hours between coats. Application Temperature: Min. +10°C / Max. + 30°C

Thinning / Blending Ratio
7 A / 1 B - Epoxy thinner 5- 10% by weight

Coverage Area
6-17 m²/L or 11-12 m²/kg (15 - 20µ DFT)

Drying Time
Touch dry in 4-5 minutes and hard dry in 24 hours.

Recommended Application Tools
Air - airless spray

Package
20 kg Set (17.5 kg A + 2.5 kg B)

Related Products
Hipox Anti-corrosive Primer VIEW DETAIL
Epoxy Coating Primer VIEW DETAIL
Unipox Epoxy Primer VIEW DETAIL
Industrial Antirust VIEW DETAIL

Sitemizin işlemesini sağlamak için çerezler kullanılmaktadır. Detaylı bilgi almak için Polisan Kansai Çerez Aydınlatma Metni'ni incelemenizi rica ederiz.